Improve safety on the road with PIAA Deno1 LED back / Rear Fog Lamp - LED third break light:

Inadequate lighting can make it difficult for a driver to see at night, snow, foggy, and rainy conditions. In order to let you get notice better to your rear car driver, the PIAA DENO1 LED rear fog light is what you need as it can also serve as the third brake light. It is easy to install this extra safety light. You need to mount the PIAA DENO1 LED light on the rear of your vehicle facing backward. It must only operate with the front fog lamps, and itsp urpose is to illuminate and signal to your rear approaching vehicles that they are approaching a slower moving vehicle. The rear fog light / third brake light beam must be red with a higher intensity than the tail lamps.

If mounting one lamp it should be mounted to the left of the vehicle centerline. If mounting two lamps they should be mounted symmetrically on either side of the vehicle centerline. Also the PIAA DENO1 LED light can also use as a 3rd break light which can wire it to your brake lights with the added safety of lights on your car.

Mounting Diagram:

Lamp for illustration only. Actual lamp may vary.

"PIAA" must read right-side up.

Mounting:

1. Find a place to mount the PIAA Deno1 back / Rear Fog lamps. They need to be mounted on the rear of the vehicle so the LEDs are clearly visible to rear approaching vehicles. Do not mount them in away that blocks or interferes with a tail or signal lamp.
2. To mount the bracket use the supplied double sided adhesive tape or the screws. (See mounting diagram)
3. Use the supplied wrench to fasten the lamp to the mounting bracket.
4. Aim the lamp then tighten the bracket fasteners.

Warning:

Power (+) Connection - This wire must be routed to the front of the vehicle and connected to the fog lamp power (+) wire using the supplied connector.

Ground (-) Connection - This wire must be connected to t chassis ground (-)

Lamp Connection - Connect the power supply wires to the PIAA Deno1 rear fog lamp. Black wire to black wire and white wire to white wire. With the pre-terminated wire ends they will only connect one way.

When installation is complete, tie the wiring out of the way. Keep it away from hot parts such as exhaust or turbos and away from moving parts such as the throttle or drive lines.

Wiring Diagram:

Ground (-) black

Positive(+) white

Lamp for illustration only. Actual lamp may vary.

Warning:

• Lighting laws vary state to state, check your local laws before use.

• This light system may be used only as auxiliary lighting.

• The lamps and wiring harness are to be used only with 12 volt automotive electrical systems.

• Using this light system while the engine is not running will drain the battery.

• Some automobiles generate high voltage at start up and when it is turned off, do no have lights on as you start or turn off your vehicle.

• Using the wrong bulbs may cause a malfunction, use only specified PIAA bulbs.